Underlayment
Ice and water shield at the eaves and valleys, with underlayment over the rest of the deck guards the deck if ice dams form.
Roof Replacement
Roof Installation Garfield, NJ
Installing a roof in Garfield comes down to doing each layer in order, from the metal edges and underlayment to the flashing and the final ridge, whether the roof is going on a stripped deck or as a permitted overlay. One call to (551) 348-2856 reaches a nearby roofing contractor.
A quality roofing material can still fail early if it is installed carelessly. Shingles nailed too high above the nail line can blow off in the first strong wind, a missing kickout flashing can rot a wall where the roof meets the siding, and a valley done wrong can funnel water under the roofing. By the time they show up, the stain is already on the ceiling.
Before anything is ordered, the roofer and homeowner settle on the roofing material. Dimensional shingles cover most houses, though metal, tile and synthetic products are growing, and each one installs differently. Pitch, the weight the framing can carry and the look you want all narrow down the choice.
Have some basics ready when you call. Know whether this is a replacement on an existing home, a new addition or a brand new house, what roofing you are considering and whether the attic has soffit vents.
Roof Installation is often paired with roof replacement and shingle roof installation, depending on the cause.
Dealing with this in Garfield, NJ right now? Call (551) 348-2856 and describe the problem to a roofer who works in Garfield.
Call nowThe process
How roof installation works
Here is the usual order for installing a shingle roof.
Check the sheathing
Before installation, the crew walks the decking and replaces soft or damaged sections. If the job is an overlay instead, the existing roof has to be flat enough to accept a new layer.
Edge metal first
Drip edge goes on at the eaves, ice and water shield is rolled out along the eaves and in the valleys, and drip edge is then added along the rakes over the underlayment. This is the part of the roof most likely to see ice and backed-up water.
Cover the deck
The remaining deck is covered with underlayment, overlapped at the seams and fastened on the maker's pattern. It is the backup layer if a shingle is ever lifted or broken.
Set the flashing
Flashing goes in as the roofing goes up: step pieces at walls, a kickout at the bottom edge and boots on every pipe. Sealant is a backup, not the flashing itself.
Lay the shingles
Starter shingles seal the first course, and each shingle is nailed through the marked nail line, not above it. Correct nailing is what lets the roof stand up to wind.
Cap the ridge
The crew opens a slot at the ridge for a ridge vent, or installs box vents, and finishes with cap shingles. Mixing different exhaust vents on one roof can short-circuit the airflow, so one system is chosen.
What is included
Parts of a new roof
Roof flashing
Step, counter and kickout flashing plus new pipe boots so the weak points match the new roof.
Roof covering
The finished roofing, installed to the maker's nailing and fastening pattern with fasteners placed where they belong.
Ventilation
An exhaust system sized for the attic for a drier attic all year.
Drip edge
Drip edge at the eaves and rakes finishes the edges cleanly.
Related service
New Roof Installation Garfield, NJ
New roof installation covers three common jobs: replacing a roof after tear-off, roofing a new home and roofing an addition. Additions take extra care, because the new roof has to tie into the old one with matching shingles, woven or flashed valleys and step flashing where the new roof meets an existing wall. Ask the roofer how the tie-in will be handled and whether any of the existing roof will be replaced to make it work.
The installation should follow the roofing maker's printed instructions, which spell out nailing, underlayment, slope limits and ventilation. Good questions for a Garfield roofing contractor include nail count, underlayment type and the ventilation plan. Clear, specific answers are a good sign the details will be done right.
Related service
Roof Overlay Garfield, NJ
With an overlay, sometimes called a layover or recover, the new roofing goes on top of the existing shingles. Most codes allow no more than two layers, which means an overlay is ruled out if there are already two, or if the deck is soft or the old shingles are buckled. It saves the labor of a tear-off and keeps the house closed during the job.
There are good reasons most roofers prefer a tear-off. The deck stays hidden, ice barrier cannot be applied directly to the wood and any wear in the old roof shows through the new one. If you do go that route, make sure the scope still includes new flashing, drip edge and pipe boots.
Local help
Roof Installation Near Me
Around Garfield, roof installation work covers older houses getting their second or third roof and newer homes adding on. Older homes in Garfield and nearby towns like Lodi, Elmwood Park, Wallington and Passaic often need extra deck work and better ventilation, while newer homes are more likely to need flashing tied into new siding, which is why the installation plan deserves as much attention as the material.
For roof installation in Garfield, NJ or nearby towns like Lodi, Elmwood Park, Wallington and Passaic, call (551) 348-2856 to reach a roofer who covers your street.
What the local climate does to a roof
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Garfield is busiest after a hard winter and before the next one.
Why call
Why fix it now
Less damage
Small roof problems caught early usually stay small repairs.
Familiar with local homes
Local roofers see the same roofs and storm damage across Garfield and nearby towns.
Clear next steps
Ask the roofer about the cause, the options and the estimate before work starts.
Common questions about roof installation
What type of roof should I install?
That depends on the house, the slope of the roof and your priorities. Architectural asphalt shingles suit most homes, metal lasts longer and sheds snow well, and tile or slate need framing that can carry their weight. A Garfield roofer can lay out the trade-offs for your roof.
What should be installed under the shingles?
A new roof should have drip edge, ice barrier along the eaves and valleys and synthetic or felt underlayment everywhere else. Ask that the written scope lists each of these, not just the shingles.
Do I need a permit for roof installation?
Requirements depend on where you live, but a permit is common for a full roof. Typically the contractor files it, and the town may inspect the finished roof.
Can a roof be installed in cold weather?
Cold weather does not stop a roof installation, but it changes the routine. Asphalt shingles get brittle in the cold and their sealant strips need warmth to bond, so crews may hand seal shingles and store bundles somewhere warmer. Nobody should work on an icy or wet roof, so weather windows matter.
How long does it take to install a new roof?
For an average house, plan on one to three days. Steep pitches, many valleys and dormers, extra deck repair or a material like tile or standing seam metal take longer.
More questions? Call (551) 348-2856
Other services that may help
Roof Replacement
Replacing an aging roof with new underlayment, flashing, vents and roofing, built to current code from the decking out.
Learn moreShingle Roof Installation
A full shingle roof system: underlayment, ice barrier, starter, flashing, shingles and ventilation, with nailing and flashing done to the shingle instructions.
Learn moreMetal Roof Installation
Metal roof installation built around the right panel, finish and trim for the house, with high-temperature underlayment and proper flashing.
Learn moreNew Construction Roofing
Roofing for new homes, additions, garages and other new framing, from dry-in to the finished ridge, so the house is protected before interior work starts.
Learn more
Looking for something else?
See all roofing servicesGet roof installation help in Garfield
Call now for Garfield roof installation and help in the towns around it.